churchyard / octoprint


OctoPrint: The responsive web interface for your 3D printer

Installation Instructions

Add the repository, install octoprint package and run it with:

systemctl start octoprint.service

To run it automatically after start, run:

systemctl enable octoprint.service

It will run on port 5000 by default. To change it to let's say 5001, add the following to /etc/octoprint.yaml:

server: port: 5001

Note that by design, you can only use ports greater than 1024. See for lower ports, such as 80.

If you want to run this on arm, which is currently not supported by Copr, only thing you'll need is to change the repo file a bit. Change $basearch to either i386 or x86_64. Since octoprint package is noarch, you shouldn't get any troubles.

Active Releases

The following unofficial repositories are provided as-is by owner of this project. Contact the owner directly for bugs or issues (IE: not bugzilla).

Release Architectures Repo Download
Fedora 26 i386 (0)*, x86_64 (1)* Fedora 26 (23 downloads)

* Total number of packages downloaded in the last seven days.